Product Introduction
After activation and use, the air pump starts to adsorb gas. When the vacuum decreases and the working conditions of the vacuum device deteriorate, the air pump can be reactivated by turning on power again to achieve the regeneration and use of the air pump.. The regeneration activation steps can be found in&quo; Activating vacuum cleaners; At the activation voltage (36V), the power on time is< 60 minutes,> After 40 minutes, the suction pump can regenerate 3-4 times. The suction agent pump can be baked and degassed with the vacuum device, or it can be separately degassed with electricity. The degassing voltage is adjusted to increase by 6-24V, and the current remains constant; Maintain for at least 20 minutes when the voltage reaches 24V at 4.5A; Only after the vacuum device is baked and degassed can the suction agent pump be activated<

Technical features
It is assembled from porous sintered air absorbers, overcoming the disadvantage of non evaporable air absorbers that are flammable when exposed to open flames in the atmosphere. The initial suction rate is high, and the suction volume is large. The porous sheet structure of the air absorber increases the suction area, allowing the gas to diffuse into the interior of the air absorber through the pores, so that the interior of the air absorber also participates in the adsorption process, greatly increasing the suction capacity of the air absorber.. The structure is simple and adopts a CF35 flange structure, which is easy to seal and connect with the vacuum system for installation< The activation method is simple. Connect the 36V power supply to the flange terminal to activate the suction agent< Excellent suction performance, with adsorption capacity for almost all active gases except inert gases<

Application Environment
The product is safe and stable in the atmosphere, but it needs to avoid dust, water vapor, and other corrosive gases. During assembly, gloves such as cotton yarn that may shed fibers cannot be used. It is recommended to use disposable rubber finger covers.; After the product is unsealed, it should be used in a timely manner and exposed to the atmosphere for no more than 24 hours. Otherwise, it must be stored under vacuum or in an inert gas protective container. The unsealed product is strictly prohibited from touching sparks or heat sources, and the temperature of the product in the atmosphere should not exceed 200 ℃, otherwise it will damage the suction performance. The quality assurance period of the unopened suction agent is one year from the date of production